Jobs Setup

The following will teach you on how to setup each of our jobs that require it.

Setting Up Mail

The following will teach you on how to setup a mail route.

Step 1. Connect to the server and spawn yourself a few mailboxes, /i 17622
Step 2. Scout out locations you wish for them to be, they should be far apart.
Step 3. Once you have found a location place down the mailbox.
Step 4. When looking at the mailbox simply type, /addbox
Step 5. Repeat above, and Success!

Best Practices

• They should be spread out much as possible, for a LARGE size map minimum should be is 12 locations.
• If you want to remove a route, simply look at the mailbox and do /removebox

Setting Up Firefighter

Step 1. Connect to the server and go to a location where you want a fire to be started
Step 2. To to the center of that location and type, /firesystem create this will give you a unquieID remember it for that location.
Step 3. You will now want to set spawn points of where fires should start by doing, /firesystem addpos unquieID
Step 4. Repeat above, and Success!

Best Practices

• They should be spread out much as possible, for a LARGE size map minimum should be is 5 locations, with 5 fire spawns at each.
• If you want to remove a firespawn, simply look at the mailbox and do /firesystem remove unquieID

Setting Up Taxi

Step 1. Connect to the server and go to a location where you want to start a taxi route
Step 2. At the location* do, /setpoint start
Step 3. Go to the location where you want to route to end and type, /setpoint end
Step 4. Repeat above, and Success!

Best Practices

• They can be close together, for a LARGE size map minimum should be is 8 locations.
• *Points should always be in the middle of the road or intersection.
• /delpoint start will delete the closest starting point.
• /delpoint end will delete the closest ending point.